We can supply nozzle products manufactured to specifications on a custom basis as following samples for example.

Lancet cutting / obliquely cutting

Lancet cutting

obliquely cutting

Lancet cutting can be applied to an injection/aspiration needle with its small puncture resistance.

Two-side/Three-side cutting with horizontal-holes

having horizontal holes, protecting the needle from penetration of rubber-plug shavings. With oblique holes instead horizontal ones, specimen can be sucked until the very little residue left.

Conical shape / Four long-holes with round shape

onical shape

Four long-holes with round shape

The picture on the left is a sample with conical shape tip.

The picture on the right is a sample that is covered by welding at the tip with four long-holes.

Micro side mirror / For reducing liquid residue

The needle end is welded with a tip part having a slant cross-section, so that the needle have no dead-volume.

Double pipe / Quatro-hole pipe

Double pipe

The double pipe on the left is consists of two SUS pipes; one of them is for sucking and the other one for bleeding.

Quatro-hole pipe

The quattro-hole pipe have a tip with four holes, welded at the end. Each holes are connected with the inner holes of the main pipe.

Hybrid pipes comprising dissimilar materials

he hybrid pipe is made of stainless pipe with PEEK inside it, having a conical shape tip.

（ » Hybrid pipes comprising dissimilar materials ）